Silent-Interface (Rip View) - H3C MSR 20-20 Command Reference Manual

Examples

silent-interface (RIP view)

Syntax
View
Parameters
Description
Examples
Send RIP-1 broadcast messages
■
Receive RIP-1 broadcast messages
■
Receive RIP-1 unicast messages
■
When RIP-2 runs on the interface in broadcast mode, the interface will:
Send RIP-2 broadcast messages
■
Receive RIP-1 broadcast messages
■
Receive RIP-1 unicast messages
■
Receive RIP-2 broadcast messages
■
Receive RIP-2 multicast messages
■
Receive RIP-2 unicast messages
■
When RIP-2 runs on the interface in multicast mode, the interface will:
Send RIP-2 multicast messages
■
Receive RIP-2 broadcast messages
■
Receive RIP-2 multicast messages
■
Receive RIP-2 unicast messages
■
# Configure Ethernet1/0 to broadcast RIP-2 messages.
<Sysname> system-view
[Sysname] interface ethernet1/0
[Sysname-Ethernet1/0] rip version 2 broadcast
silent-interface { all | interface-type interface-number }
undo silent-interface { all | interface-type interface-number }
RIP view
all: Silents all interfaces.
interface-type interface-number: Specifies an interface.
Use the
silent-interface
sending routing updates. That is, the interface only receives but does not send RIP
messages.
Use the undo silent-interface
By default, all interfaces are allowed to send routing updates.
# Configure all interfaces to work in the silent mode, and then activate
Ethernet1/0.
command to disable an interface or all interfaces from
command to restore the default.
1181