1180
C
77: RIP C
HAPTER
View
Parameters
Description
Examples
rip version
Syntax
View
Parameters
Description
C
ONFIGURATION
OMMANDS
undo rip triggered
Interface view
None
Use the
rip triggered
Use the
undo rip triggered
By default, the triggered RIP is disabled.
Note that triggered RIP can only run on link layer protocols PPP, Frame Relay, and
X.25.
# Enable triggered RIP.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] rip triggered
rip version { 1 | 2 [ broadcast | multicast ] }
undo rip version
Interface view
1: RIP version 1.
2: RIP version 2.
broadcast: Sends RIP-2 messages in broadcast mode.
multicast: Sends RIP-2 messages in multicast mode.
Use the
rip version
Use the
undo rip version
By default, no RIP version is configured for an interface, which uses the global RIP
version. If the global RIP version is not configured, the interface can only send
RIP-1 broadcasts and can receive RIP-1 broadcasts and unicasts, and RIP-2
broadcasts, multicasts and unicasts.
If RIP-2 is specified with no sending mode configured, RIP-2 messages will be sent
in multicast mode.
When RIP-1 runs on an interface, the interface will:
command to enable triggered RIP.
command to disable triggered RIP.
command to specify a RIP version for the interface.
command to remove the specified RIP version.