Debugging Bgp Update - H3C MSR 20-20 Command Reference Manual

debugging bgp update

Syntax
View
Default Level
Parameters
Description
// The hold timer expired on BGP peer 2.2.2.2.
debugging bgp update [ acl acl-number | ip-prefix ip-prefix-name] [ receive | send ] [
verbose ]
undo debugging bgp update [ acl acl-number | ip-prefix ip-prefix-name] [ receive |
send ] [ verbose ]
User view
1: Monitor level
acl acl-number: Specifies an access control list (ACL) for filtering packet
debugging information. The acl-number argument ranges from 2000 to 3999.
ip-prefix ip-prefix-name: Specifies an IP prefix list for filtering the packet
debugging information. ip-prefix-name is a string of 1 to 19 characters.
receive: Enables the debugging for received BGP packets.
send: Enables the debugging for sent BGP packets.
verbose: Displays detailed debugging information.
Use the debugging bgp update
Update messages.
Use the
undo debugging bgp update
Update messages.
By default, this debugging is disabled.
Enabling debugging may affect system performance; therefore, use this command
only when necessary and disable debugging once the debugging operation is
complete.
Table 230 Description on the fields of the debugging bgp update command
Field
BGP.xxx
Err/SubEr
Errdata:
x.x.x.x/xx
RPM policy failed for policy :
name:xx :
INBOUND
tnl id
command to enable debugging for BGP
command to disable debugging for BGP
Description
BGP instance name
Error code/error subcode
Error data
Destination address/mask
Failed to pass policy xx
Inbound policy
Tunnel ID
1025