State-Refresh-Rate-Limit (Pim View); State-Refresh-Ttl (Pim View) - H3C MSR 20-20 Command Reference Manual

1426 C 90: PIM C
HAPTER
Example

state-refresh-rate-limit (PIM view)

Syntax
View
Parameter
Description
Related command:
Example

state-refresh-ttl (PIM view)

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
# Set the state refresh interval to 70 seconds in the public instance.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-interval 70
state-refresh-rate-limit interval
undo state-refresh-rate-limit
Public instance PIM view, VPN instance PIM view
interval: Time to wait before receiving a new refresh message, in seconds and with
an effective range of 1 to 65535.
Use the
state-refresh-rate-limit
must wait before receiving a new state refresh message.
Use the
undo state-refresh-rate-limit
By default, the device waits 30 seconds before receiving a new state refresh
message.
pim state-refresh-capable, state-refresh-interval (PIM view), and
state-refresh-ttl (PIM view).
# In the public instance configure the device to wait 45 seconds before receiving a
new state refresh message.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-rate-limit 45
state-refresh-ttl ttl-value
undo state-refresh-ttl
Public instance PIM view, VPN instance PIM view
ttl-value: TTL value of state refresh messages, in the range of 1 to 255.
Use the
state-refresh-ttl
messages.
Use the
undo state-refresh-ttl
command to configure the time the router
command to restore the default setting.
command to configure the TTL value of state refresh
command to restore the default setting.