1554
C
95: MPLS B
HAPTER
View
Parameter
Description
Related command:
Example
mtu-signalling
Syntax
View
Parameter
Description
Example
C
C
ASICS
ONFIGURATION
OMMANDS
System view
lsr-id: ID for identifying the LSR, in dotted decimal notation.
Use the
mpls lsr-id
Use the
undo mpls lsr-id
By default, no LSR ID is configured.
Your must configure the LSR ID of an LSR before configuring any other MPLS
commands.
You are recommended to use the address of a loopback interface on the LSR as
the ID.
display mpls interface.
# Set the LSR ID to 3.3.3.3.
<Sysname> system-view
[Sysname] mpls lsr-id 3.3.3.3
mtu-signalling
undo mtu-signalling
MPLS LDP view
None
Use the
mtu-signalling
Use the
undo mtu-signalling
By default, MTU signaling is enabled.
Enabling/disabling MTU signaling will cause the existing sessions to be
reestablished, and the LSPs established by the sessions to be deleted and
reestablished.
# Enable MTU signaling.
<Sysname> System-view
[Sysname] mpls ldp
[Sysname-mpls-ldp] mtu-signalling
command to configure the ID of an LSR.
command to remove the ID of an LSR.
command to enable MTU signaling.
command to disable MTU signaling.