Dot1X Max-User - H3C MSR 20-20 Command Reference Manual

1904 C 126: 802.1
HAPTER

dot1x max-user

Syntax
View
Parameter
Description
Related command:
Example
C C
X ONFIGURATION OMMANDS
In system view:
dot1x max-user user-number [ interface interface-list ]
undo dot1x max-user [ interface interface-list ]
In Ethernet interface view:
dot1x max-user user-number
undo dot1x max-user
System view/interface view
user-number: Maximum number of users to be supported simultaneously. The
valid settings and the default may vary by device.
interface interface-list: Specifies an Ethernet port list, which can contain multiple
Ethernet ports. The interface-list argument is in the format of interface-list =
{ interface-type interface-number [ to interface-type interface-number ] } &
<1-10>, where interface-type represents the port type, interface-number
represents the port number, and & <1-10> means that you can provide up to 10
port indexes/port index lists for this argument. The start port number must be
smaller than the end number and the two ports must of the same type.
Use the dot1x max-user
supported simultaneously for specified or all ports.
Use the
undo dot1x max-user
Note that:
With no interface specified, the command sets the threshold for all ports when
■
issued in system view.
When issued in interface view, this command applies to that port only. The
■
interface interface-list keyword and argument are not available in interface
view.
display dot1x.
# Set the maximum number of users for port Ethernet 1/1 to support
simultaneously as 32.
<Sysname> system-view
[Sysname] dot1x max-user 32 interface ethernet 1/1
Or
command to set the maximum number of users to be
command to restore the default.