Gre Checksum; Encapsulation-Limit - H3C MSR 20-20 Command Reference Manual

1752 C 103: GRE C
HAPTER

encapsulation-limit

Syntax
View
Parameter
Description
Example

gre checksum

Syntax
View
C
ONFIGURATION OMMANDS
Table 469 Description on the fields of the display ipv6 interface tunnel command
Field
Tunnel0 current state
Line protocol current state
IPv6
link-local address
Global unicast address(es)
Joined group address(es)
MTU
ND reachable time
ND retransmit interval
Hosts use stateless autoconfig
for addresses
encapsulation-limit [ number ]
undo encapsulation-limit
Tunnel interface view
number: Number of encapsulations in a tunnel, in the range 1 to 10.
Use the encapsulation-limit
encapsulations on a tunnel.
Use the
undo encapsulation-limit
By default, the maximum encapsulation limit is 4.
The encapsulation limit applies to only IPv6 over IPv6 tunnels.
# Configure the encapsulation limit on a tunnel to 3.
<Sysname1> system-view
[Sysname1] interface tunnel 2
[Sysname-tunnel2] encapsulation-limit 3
gre checksum
undo gre checksum
Tunnel interface view
Description
Status of the physical layer of the tunnel interface, UP or
DOWN
Status of the link layer of the tunnel interface, UP or DOWN
Whether IPv6 is enabled on the tunnel interface
Link-local address of the tunnel interface
Global unicast addresses of the tunnel interface
Multicast addresses of the tunnel interface
Maximum transmission unit of the tunnel
Interval during which the neighbor is considered reachable
Neighbor discovery packet retransmission interval
Hosts use the stateless auto-configuration mode to acquire
an IPv6 addresses.
command to configure the maximum number of
command to remove the configuration.