Display Debugging Ospfv3 - H3C MSR 20-20 Command Reference Manual

View
Parameters
Description
Related commands:
Examples

display debugging ospfv3

Syntax
View
Parameters
Description
Examples
undo default-cost
OSPFv3 area view
value: Specifies a cost for the default route advertised to the stub area, in the
range of 0 to 65535. The default is 1.
Use the
default-cost
advertised to the stub area.
Use the undo-default-cost
Use of this command is only available on the ABR that is connected to a stub area.
You have two commands to configure a stub area: stub, defaulted-cost. You
need to use the stub command on routers connected to a stub area to configure
the area as stub.
If multiple OSPFv3 processes are running, use of this command takes effect only
for the current process.
stub(OSPFv3 area view).
# Configure Area1 as a stub area, and specify the cost of the default route
advertised to the stub area as 60.
<Sysname> system-view
[Sysname] ospfv3
[Sysname-ospfv3-1] area 1
[Sysname-ospfv3-1-area-0.0.0.1] stub
[Sysname-ospfv3-1-area-0.0.0.1] default-cost 60
display debugging ospfv3
Any view
None
Use the display debugging ospfv3
debugging state information.
# Display the global OSPFv3 debugging state information.
<Sysname> display debugging ospfv3
OSPFv3 External route calculation debugging is on
command to specify the cost of the default route to be
command to restore the default value.
command to display global OSPFv3
1281