State - H3C MSR 20-20 Command Reference Manual

Description
Related command:
Example

state

Syntax
View
Parameter
Description
standard: Specifies the standard RADIUS server, which requires the RADIUS client
end and RADIUS server to interact according to the regulation and packet format
of the standard RADIUS protocol (RFC 2865/2866 or newer).
Use the command to specify the RADIUS server type supported by
server-type
the device.
Use the undo server-type
By default, the supported RADIUS server type is standard.
radius scheme.
# Set the RADIUS server type of RADIUS scheme radius1 to standard.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] server-type standard
state { primary | secondary } { accounting | authentication } { active | block }
RADIUS scheme view
primary: Sets the status of the primary RADIUS server.
secondary: Sets the status of the secondary RADIUS server.
accounting: Sets the status of the RADIUS accounting server.
authentication: Sets the status of the RADIUS authentication/authorization
server.
active: Sets the status of the RADIUS server to active, namely the normal
operation state.
block: Sets the status of the RADIUS server to block.
Use the command to set the status of a RADIUS server.
state
By default, every RADIUS server configured with an IP address in the RADIUS
scheme is in the state of active.
Note that:
When a primary server, authentication/authorization server or accounting
■
server, fails, the device automatically turns to the secondary server.
Once the primary server fails, the primary server transfers into the state of
■
block, and the device turns to the secondary server. In this case, if the
secondary server is available, the device triggers the primary server quiet timer.
command to restore the default.
1969