Display Ospf Vlink - H3C MSR 20-20 Command Reference Manual

display ospf vlink

Syntax
View
Parameters
Description
Examples
Total Nets: 2
Intra Area: 1 Inter Area: 1
Table 276 Description on the fields of the display ospf routing command
Field
Destination
Cost
Type
NextHop
AdvRouter
Area
Total Nets
Intra Area
Inter Area
ASE
NSSA
display ospf [ process-id ] vlink
Any view
process-id: OSPF process ID, in the range 1 to 65535.
Use the
display ospf vlink
If no OSPF process is specified, the OSPF virtual link information of all OSPF
processes is displayed.
# Display OSPF virtual link information.
<Sysname> display ospf vlink
OSPF Process 1 with Router ID 3.3.3.3
Virtual Links
Virtual-link Neighbor-ID
Interface: 10.1.2.1 (Serial2/0)
Cost: 1562 State: P-2-P
Transit Area: 0.0.0.1
Timers: Hello 10 , Dead 40 , Retransmit 5 , Transmit Delay 1
Table 277 Description on the fields of the display ospf vlink command
Field
Virtual-link Neighbor-id
Neighbor-State
Interface
ASE: 0 NSSA: 0
Description
Destination network
Cost to destination
Route type: intra-area, Transit, stub, Inter-area, Type1 External,
Type2 External.
Next hop address
Advertising router
Area ID
Total routes
Total intra-area routes
Total inter-area routes
Total ASE routes
Total NSSA routes
command to display OSPF virtual link information.
-> 2.2.2.2, Neighbor-State: Full
Type: Virtual
Description
ID of neighbor connected to the router via the virtual link
Neighbor State: Down, Attempt, Init, 2-Way, ExStart, Exchange,
Loading, Full.
Local interface's IP address and name of the virtual link
1129