Isis Timer Retransmit; Is-Level - H3C MSR 20-20 Command Reference Manual

Examples

isis timer retransmit

Syntax
View
Parameters
Description
Related commands:
Examples

is-level

Syntax
View
n
This command is not available in loopback interface view.
# Configure the interval as 500 milliseconds for sending LSPs on interface serial
2/0.
<Sysname> system-view
[Sysname] interface serial2/0
[Sysname-Serial2/0] isis timer lsp 500
isis timer retransmit seconds
undo isis timer retransmit
Interface view
seconds: Specifies the interval in seconds for retransmitting LSP packets, ranging
from 1 to 300.
Use the
isis timer retransmit
retransmitting LSP packets over point-to-point link.
Use the undo isis timer retransmit
You need not use this command over a broadcast link where no LSP response is
required.
isis timer lsp.
n
This command is not available in loopback interface view.
■
Configure a proper time to avoid unnecessary retransmissions.
■
# Configure the LSP retransmission interval as 10 seconds for the serial2/0
interface.
<Sysname> system-view
[Sysname] interface serial2/0
[Sysname-Serial2/0] isis timer retransmit 10
is-level { level-1 | level-1-2 | level-2 }
undo is-level
IS-IS view
command to configure the interval for
command to restore the default of 5s.
1073