Lsp-Fragments-Extend; Log-Peer-Change (Is-Is View) - H3C MSR 20-20 Command Reference Manual

1076 C 74: IS-IS C
HAPTER

log-peer-change (IS-IS view)

Syntax
View
Parameters
Description
Examples

lsp-fragments-extend

Syntax
View
Parameters
C
ONFIGURATION OMMANDS
log-peer-change
undo log-peer-change
IS-IS view
None
Use the
log-peer-change
changes.
Use the
undo log-peer-change
The feature is enabled by default.
After the feature is enabled, information about IS-IS adjacency state changes is
sent to the configuration terminal.
# Enable logging on the IS-IS adjacency state changes.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] log-peer-change
lsp-fragments-extend [ [ level-1 | level-2 | level-1-2 ] | [ mode-1 | mode-2 ] ] *
undo lsp-fragments-extend
IS-IS view
mode-1: Fragment extension mode 1, used on a network where some routers do
not support LSP fragment extension.
mode-2: Fragment extension mode 2, used on a network where all routers
support LSP fragment extension.
level-1: Applies the fragment extension mode to Level-1 LSPs.
level-2: Applies the fragment extension mode to Level-2 LSPs.
level-1-2: Applies the fragment extension mode to both Level-1 and Level-2 LSPs.
n
The mode-1 and level-1-2 keywords are used by default.
command to enable logging on IS-IS adjacency state
command to disable the logging.