Mpls Te Max-Link-Bandwidth; Mpls Te Max-Reservable-Bandwidth - H3C MSR 20-20 Command Reference Manual

1626 C 96: MPLS TE C
HAPTER
View
Parameter
Description
Example

mpls te max-link-bandwidth

Syntax
View
Parameter
Description
Example

mpls te max-reservable-bandwidth

Syntax
C
ONFIGURATION OMMANDS
Tunnel interface view
None
Use the mpls te loop-detection
loop detection when setting up the MPLS TE tunnel.
Use the
undo mpls te loop-detection
Loop detection is disabled by default.
# Configure the node to perform loop detection when setting up tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te loop-detection
mpls te max-link-bandwidth bandwidth-value [ bc1 bc1-bandwidth ]
undo mpls te max-link-bandwidth
Interface view
bandwidth-value: Maximum link bandwidth available for RSVP traffic, in the range
1 to 32000000 kbps.
bc1 bc1-bandwidth: Reservable bandwidth in kbps on the interface, in the range 1
to bandwidth-value.
Use the mpls te max-link-bandwidth bandwidth-value
configure maximum link bandwidth.
Use the
undo mpls te max-link-bandwidth
configuration.
The configured maximum bandwidth is available for both MPLS traffic and
common best-effort traffic.
# On interface Serial 1/0 set maximum link bandwidth available for RSVP traffic to
1158 kbps, and the reservable bandwidth to 200 kbps.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] mpls te max-link-bandwidth 1158 bc1 200
mpls te max-reservable-bandwidth bandwidth-value [ bc1 bc1-bandwidth ]
command to configure the node to perform
command to disable loop detection.
command to remove the
command to