Rip Summary-Address; Rip Triggered - H3C MSR 20-20 Command Reference Manual

Examples

rip summary-address

Syntax
View
Parameters
Description
Related commands:
Examples

rip triggered

Syntax
In special cases, make sure it is necessary to disable the split horizon function.
■
In Frame Relay, X.25 and other non-broadcast multi-access (NBMA) networks,
■
split horizon should be disabled if multiple VCs are configured on the primary
and secondary interfaces to ensure route advertisement. For detailed
information, refer to "Frame Relay Configuration Commands" on page 371
and "LAPB and X.25 Configuration Commands" on page 421.
n
Only the poison reverse function takes effect if both the split horizon and poison
reverse functions are enabled.
# Enable the split horizon function on Ethernet1/0.
<Sysname> system-view
[Sysname] interface ethernet1/0
[Sysname-Ethernet1/0] rip split-horizon
rip summary-address ip-address { mask | mask-length }
undo rip summary-address ip-address { mask | mask-length }
Interface view
ip-address: Summary IP address.
mask: Subnet mask in dotted decimal format.
mask-length: Subnet mask length.
Use the
rip summary-address
summary route via the interface.
Use the
undo rip summary-address
Note that the summary address is valid only when the automatic summarization is
disabled.
summary.
# Advertise a local summary IP address on Ethernet1/0.
<Sysname> system-view
[Sysname] interface ethernet1/0
[Sysname-Ethernet1/0] rip summary-address 10.0.0.0 255.255.255.0
rip triggered
command to configure RIP-2 to advertise a
command to remove the configuration.
1179