Timer Spt-Switch (Pim View) - H3C MSR 20-20 Command Reference Manual

Related command:
Example

timer spt-switch (PIM view)

Syntax
View
Parameter
Description
Related command:
Example
Use the
undo timer join-prune
By default, the join/prune interval is 60 seconds.
pim timer join-prune.
# Set the global join/prune interval to 80 seconds in the public instance.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] timer join-prune 80
timer spt-switch interval
undo timer spt-switch
Public instance PIM view, VPN instance PIM view
interval: Interval in seconds between checks of the traffic rate threshold prior to
RPT-to-SPT switchover, in the range of 15 to 65,535.
Use the timer spt-switch
the traffic rate threshold before RPT-to-SPT switchover.
Use the
undo timer spt-switch
By default, the traffic rate threshold is checked at an interval of 15 seconds before
RPT-to-SPT switchover.
Before using this command, be sure to use the spt-switch-threshold command
to configure the traffic rate threshold that should trigger RPT-to-SPT switchover.
Otherwise, the interval set in this command will be meaningless.
spt-switch-threshold (PIM view).
# In the public instance set the interval between checks of the traffic rate
threshold prior to RPT-to-SPT switchover to 30 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] timer spt-switch 30
command to restore the default setting.
command to configure the interval between checks of
command to restore the default setting.
1429