Mpls Te Igp Advertise - H3C MSR 20-20 Command Reference Manual

Msr 20/30/50 series routers
Hide thumbs Also See for MSR 20-20:
Table of Contents

Advertisement

Example

mpls te igp advertise

Syntax
View
Parameter
Description
Example
You may perform the mpls te fast-reroute bypass-tunnel command multiple
times to specify multiple bypass tunnels for the protected interface. At present, a
maximum of three bypass tunnels can be specified for a protected interface.
When specifying a bypass tunnel, consider the following:
The state of the tunnel must be up.
The protected interface is not the outgoing interface in the route entries for the
LSP of the bypass tunnel.
n
A bypass tunnel cannot be used for services like VPN at the same time.
This command is not supported when the signaling protocol is CR-LDP.
# Use Tunnel 0 as the bypass tunnel to protect the link connected to interface
Ethernet 1/0.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] mpls te fast-reroute bypass-tunnel tunnel 0
mpls te igp advertise [ hold-time value ]
undo mpls te igp advertise
Tunnel interface view
hold-time value: Sets the delay that IGP waits to notify IGP neighbors of the
down event of the TE tunnel. It ranges from 0 to 4294967295 milliseconds. The
default is 0 milliseconds.
Use the
mpls te igp advertise
tunnel as a link to IGP neighbors.
Use the
undo mpls te igp advertise
By default, IGP does not advertise MPLS TE tunnels to IGP neighbors.
n
The mpls te igp advertise command cannot be used together with the mpls te
igp shortcut command.
# Set the hold time to 10000 milliseconds.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te igp advertise hold-time 10000
command to enable IGP to advertise the MPLS TE
command to remove the configuration.
1623

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msr 20-21Msr 30-16Msr 30-20Msr 30-40Msr 30-60Msr 50 ... Show all

Table of Contents