1516
C
95: MPLS B
HAPTER
display mpls label
Syntax
View
Parameter
Description
Example
C
C
ASICS
ONFIGURATION
OMMANDS
Table 368 Description on the fields of the display mpls interface command
Field
Status
TE Attr/TE Attribute
LSPCount
CR-LSPCount
FRR
n
For information about FRR, refer to "MPLS TE Configuration Commands" on page
1565.
display mpls label { label-value1 [ to label-value2 ] | all }
Any view
all: Specifies all labels.
label-value1: Specifies a label or, when used with the label-value2 argument, the
start label of a range of labels. The value of this argument ranges from 16 to
8191.
to label-value2: End label of a range of labels, in the range 16 to 8191.
all: Specifies all labels.
Use the
display mpls label
specified or all labels.
# Display the status of a specified label.
<Sysname> display mpls label 1280
Label alloc state: '.' means not used, '$' means used
-------------Dynamic Label--------------------------------
1280:.
# Display the status of all labels.
<Sysname> display mpls label all
---------------------------------------------------------------------
Label alloc state: '.' means not used, '$' means used
------------------------Static Label---------------------------------
16:.... ........ ........ ........
976:........ ........ ........ ........
------------------------Dynamic Label--------------------------------
1024: $ $$...... ........ ........
1088:.. ........ ........ ........
Description
Status of the interface
Whether TE is enabled on the interface
Number of LSPs on the interface
Number of CR-LSPs on the interface
Whether FRR is enabled on the interface. If FRR is enabled, the
output will also include the bound tunnels.
command to display the status of one or more
........ ........ ........ ........
........ ........
........ ........ ........ ........
........ ........ ........ ........