Display Interface Tunnel - H3C MSR 20-20 Command Reference Manual

1750 C 103: GRE C
HAPTER

display interface tunnel

Syntax
View
Parameter
Description
Related command:
Example
C
ONFIGURATION OMMANDS
display interface tunnel [ number ]
Any view
number: Tunnel interface number.
Use the
display interface tunnel
specified or all tunnel interfaces.
If the number argument is not specified, the command displays information about
all tunnel interfaces.
source, destination, gre key, gre checksum, and tunnel-protocol on page
887.
# Display information about interface Tunnel0.
<Sysname> display interface tunnel 0
Tunnel0 current state: UP
Line protocol current state: UP
Description: Tunnel0 Interface
The Maximum Transmit Unit is 64000
Internet Address is 10.1.2.1/24 Primary
Encapsulation is TUNNEL, aggregation ID not set
Tunnel source 192.13.2.1, destination 192.13.2.2
Tunnel keepalive disable
Tunnel protocol/transport GRE/IP
GRE key value is 123
Checksumming of GRE packets enabled
Last 300 seconds input:
Last 300 seconds output:
361 packets input,
0 input error
361 packets output,
0 output error
Table 468 Description on the fields of the display interface tunnel command
Field
Tunnel0 current state
Line protocol current state
Description
Tunnel0 Interface
Maximum Transmit Unit
Encapsulation is TUNNEL
aggregation ID
command to display information about a
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
9953388 bytes
30324 bytes
Description
Status of the physical layer of the tunnel interface, UP or
DOWN
Status of the link layer of the tunnel interface, UP or DOWN
Descriptive information of the tunnel interface
Number of the tunnel interface
Maximum transmission unit on the tunnel
The encapsulation protocol is TUNNEL.
ID of the link aggregation group applied to the tunnel. If
the device does not support link aggregation group
configuration or no link aggregation group is specified, the
message "aggregation ID not set" is displayed.