Dar Protocol-Rename; Dar Protocol-Statistic - H3C MSR 20-20 Command Reference Manual

1864 C 124: DAR C
HAPTER
Description
Examples

dar protocol-rename

Syntax
View
Parameters
Description
Examples

dar protocol-statistic

Syntax
C
ONFIGURATION OMMANDS
Use the dar protocol
protocol.
Use the
undo dar protocol
value.
By default, port number is specified for the protocols except for the ten
user-defined protocols, RTP and RTCP.
# Set the port number of RTP protocol to 36000, 36001, or 40000 to 40999.
<Sysname> system-view
[Sysname] dar protocol rtp udp port 36000 36001 range 40000 40999
dar protocol-rename old-name user-defined-name
undo dar protocol-rename user-defined-name
System view
old-name: Initial name of the user-defined protocol, which are user-defined01,
user-defined02, ..., user-defined10.
user-defined-name: New name of the user-defined protocol, in the length of 1 to
14 characters. The new name cannot be the same with any existing name, and
cannot be all, total, tcp, udp, ip or user-defined01, user-defined02, ...,
user-defined10.
Use the
dar protocol-rename
Use the
undo dar protocol-rename
By default, the names of the user-defined protocols are user-defined01,
user-defined02, ..., user-defined10.
# Rename the user-defined01 protocol to hello.
<Sysname> system-view
[Sysname] dar protocol-rename user-defined01 hello
# Restore the default name of the user-defined01 protocol.
<Sysname> system-view
[Sysname] undo dar protocol-rename hello
dar protocol-statistic [ flow-interval time ]
command to configure the port number of DAR application
command to restore the port number to default
command to rename the user-defined protocol.
command to restore the default name.