Mpls Rsvp-Te Timer Retransmission - H3C MSR 20-20 Command Reference Manual

1614 C 96: MPLS TE C
HAPTER
Parameter
Description
Related command:
Example

mpls rsvp-te timer retransmission

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
timevalue: Refresh interval, in the range 10 to 65535 seconds.
Use the mpls rsvp-te timer refresh
path/reservation state refresh interval.
Use the
undo mpls rsvp-te timer refresh
The default path/reservation state refresh interval is 30 seconds.
mpls rsvp-te keep-multiplier.
# Set the path/reservation state refresh interval to 60 seconds.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls rsvp-te timer refresh 60
mpls rsvp-te timer retransmission { increment-value [ increment-value ] |
retransmit-value [ retrans-timer-value ] } *
undo mpls rsvp-te timer retransmission
Interface view
increment-value increment-value: Increment value delta, in the range 1 to 10.
The default is 1.
retransmit-value retrans-timer-value: Initial retransmission interval, in the range
500 to 3000 milliseconds. The default is 500 milliseconds.
Use the mpls rsvp-te timer retransmission
message retransmission.
Use the
undo mpls rsvp-te timer retransmission
default.
By default, RSVP message retransmission is disabled.
On an interface enabled with the Message_ID (reliability) mechanism, you may
configure RSVP message retransmission. After the interface sends an RSVP
message, it waits for an acknowledgement. If no ACK is received before the initial
retransmission interval (Rf seconds for example) expires, the interface resends the
message. After that, the interface resends the message at an exponentially
increased retransmission interval equivalent to (1 + Delta) × Rf seconds either until
an acknowledgement is received or the retransmission attempt limit RI is reached.
The Delta governs the speed with which the interface increases the retransmission
interval.
command to configure the
command to restore the default.
command to enable RSVP
command to restore the