Reset Isis All - H3C MSR 20-20 Command Reference Manual

1080 C 74: IS-IS C
HAPTER
Description
Examples

reset isis all

Syntax
View
Parameters
Description
Related commands:
Examples
C
ONFIGURATION OMMANDS
Use the preference
Use the
undo preference
By default, the IS-IS protocol preference is 15.
If a routing policy is specified in this command, the preference (if any) set by the
routing policy applies to those matched routes. Other routes use the preference
set by the preference command.
When a router runs multiple routing protocols at the same time, the system will
set a preference to each routing protocol. If several protocols find routes to the
same destination, the route of the routing protocol with the highest preference is
selected.
# Configure the preference of IS-IS protocol as 25.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] preference 25
reset isis all [ process-id | vpn-instance vpn-instance-name ]
User view
process-id: Clears the data structure information of an IS-IS process numbered
from 1 to 65535.
vpn-instance-name: Clears the data structure information of a VPN instance
named with a string of 1 to 31 characters.
Use the
reset isis all
No data structure information is cleared by default.
This command is used when the LSP needs to be updated immediately. For
example, after performing the area-authentication-mode and
domain-authentication-mode commands, you can use this command to clear
old LSPs.
area-authentication-mode, domain-authentication-mode.
# Clear all IS-IS data structure information.
<Sysname> reset isis all
command to configure the preference for IS-IS protocol.
command to restore the default.
command to clear all ISIS data structure information.