Default-Cost (Ospf Area View) - H3C MSR 20-20 Command Reference Manual

View
Parameters
Description
Related commands:
Examples

default-cost (OSPF area view)

Syntax
View
Parameters
Description
undo default { cost | limit | tag | type } *
OSPF view
cost: Specifies the default cost for redistributed routes, in the range 0 to
16777214.
limit: Specifies the default upper limit of routes redistributed per time, in the range
1 to 2147483647.
tag: Specifies the default tag for redistributed routes, in the range 0 to
4294967295.
type: Specifies the default type for redistributed routes: 1 or 2.
Use the command to configure default parameters for redistributed
default
routes: cost, route type (Type1 or Type2), tag, and the upper limit.
Use the
undo default
The cost, route type, tag, and the upper limit are 1, 2, 1 and 1000 by default.
import-route (OSPF view).
# Configure default parameters cost as 10, upper limit as 20000, tag as 100 and
type as 2 for redistributed external routes.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] default cost 10 limit 20000 tag 100 type 2
default-cost cost
undo default-cost
OSPF area view
cost: Specifies a cost for the default route advertised to the Stub or NSSA area, in
the range 0 to 16777214.
Use the
default-cost
to the stub or NSSA area.
Use the
undo default-cost
The cost defaults to 1.
This command is only applicable to the ABR of a stub area or the ABR/ASBR of an
NSSA area.
command to restore default values.
command to specify a cost for the default route advertised
command to restore the default value.
1111