Mpls Te Resv-Style; Mpls Te Retry - H3C MSR 20-20 Command Reference Manual

Example

mpls te resv-style

Syntax
View
Parameter
Description
Example

mpls te retry

Syntax
Use the
undo mpls te reoptimization
the tunnel.
Reoptimization is disabled by default.
n
The reoptimization function cannot be used together with these commands:
mpls te auto-bandwidth adjustment, mpls te route-pinning, mpls te
backup, and mpls te resv-style ff.
# Enable reoptimization, setting the reoptimization (automatic rerouting)
frequency to 43200 seconds (12 hours).
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te reoptimization frequency 43200
mpls te resv-style { ff | se }
undo mpls te resv-style
Tunnel interface view
ff: Sets the resource reservation style to fixed filter (FF).
se: Sets the resource reservation style to shared explicit (SE).
Use the
mpls te resv-style
MPLS TE tunnel.
Use the undo mpls te resv-style
The default resource reservation style is SE.
You may configure FF and SE only when the signaling protocol is set to RSVP-TE.
# Adopt the FF reservation style when setting up the CR-LSP tunnel for TE tunnel
0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te resv-style ff
mpls te retry times
undo mpls te retry
command to disable reoptimization on
command to set the resource reservation style for the
command to restore the default.
1631