Register-Whole-Checksum (Ipv6 Pim View); Reset Pim Ipv6 Control-Message Counters - H3C MSR 20-20 Command Reference Manual

register-whole-checksum (IPv6 PIM view)

Syntax
View
Parameter
Description
Related command:
Example

reset pim ipv6 control-message counters

Syntax
View
Parameter
Description
Example
register-whole-checksum
undo register-whole-checksum
IPv6 PIM view
None
Use the
register-whole-checksum
calculate the checksum based on the entire register message.
Use the undo register-whole-checksum
configuration.
By default, the checksum is calculated based only on the header in the register
message.
register-policy (IPv6 PIM view) and register-suppression-timeout (IPv6 PIM
view).
# Configure the router to calculate the checksum based on the entire register
message.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] register-whole-checksum
reset pim ipv6 control-message counters [ interface interface-type
interface-number ]
User view
interface-type interface-number: Specifies to reset the IPv6 PIM control message
counter on a particular interface. If no interface is specified, this command will
clear the statistics information about IPv6 PIM control messages on all interfaces.
Use the
reset pim ipv6 control-message counters
PIM control message counters.
# Reset IPv6 PIM control message counters on all interfaces.
<Sysname> reset pim ipv6 control-message counters
command to configure the router to
command to restore the default
command to reset IPv6
1495