protocol: Routing protocol, which can have any of the following values:
bgp: Specifies the BGP protocol
■
isis: Specifies the IS-IS protocol
■
ospf: Specifies the OSPF protocol
■
rip: Specifies the RIP protocol
■
process-id: Process number of the unicast routing protocol, in the range of 1 to
65535. This argument must be provided if IS-IS, OSPF or RIP is the specified unicast
routing protocol.
policy-name: Name of the multicast route match rule, a case sensitive string of up
to 19 characters.
rpf-nbr-address: IP address of the PPF neighbor.
interface-type interface-number: Specifies the interface type and number of an
RPF neighbor. The interface type must not be Ethernet, GigabitEthernet, Loopback
or Vlan-interface.
preference: Route preference, in the range of 1 to 255 and defaulting to 1.
order-number: Match order for routes on the same segment, in the range of 1 to
100.
Description
Use the
Use the
from the multicast static routing table.
By default, no multicast static route is configured.
Note that:
The arguments source-address { mask | mask-length }, protocol and
■
policy-name are critical elements in multicast static route configuration. The
variation of any of these three arguments results in a different configuration.
In the configuration, you can use the display multicast routing-table static
■
command to check whether the multicast static route information contains this
configuration. If you find a match, modify the corresponding fields without
changing the configuration sequence; otherwise, add a multicast static route.
When configuring a multicast static route, you cannot designate an RPF
■
neighbor by specifying an interface (by means of the interface-type
interface-number command argument combination) if the interface type of
that router is Ethernet, GigabitEthernet, Loopback or Vlan-interface; instead,
you can designate an RPF neighbor only by specifying an address
(rpf-nbr-address).
Because outgoing interface iteration may fail or the specified interface may be
■
in the down state, the multicast static route configured with this command
may fail to take effect. Therefore, we recommend that you use the display
multicast routing-table static command after you configure a multicast
command to configure a multicast static route.
ip rpf-route-static
undo ip rpf-route-static
command to delete a multicast static route
1335