Static-Rp (Pim View) - H3C MSR 20-20 Command Reference Manual

Related command:
Example

static-rp (PIM view)

Syntax
View
Parameter
Description
By default, the TTL value of state refresh messages is 255.
pim state-refresh-capable, state-refresh-interval (PIM view), and
state-refresh-rate-limit (PIM view).
# In the public instance configure the device to send PIM state refresh messages
with a TTL of 45.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-ttl 45
static-rp rp-address [ acl-number ] [ preferred ]
undo static-rp rp-address
Public instance PIM view, VPN instance PIM view
rp-address: IP address of the static RP to be configured. This address must be a
legal unicast IP address, rather than an address on the 127.0.0.0/8 segment.
acl-number: Basic ACL number, in the range of 2000 to 2999. If you provide this
argument, the configured static RP will serve only those groups that pass the ACL
filtering; otherwise, the configured static RP will serve the all-system group
224.0.0.0/4.
preferred: Specifies to give priority to the static RP if the static RP conflicts with
the dynamic RP. If you do not include the preferred keyword in your command,
the dynamic RP will be given priority, and the static RP takes effect on if no
dynamic RP exists in the network or when the dynamic RP fails.
Use the static-rp command to configure a static RP.
Use the
undo static-rp
By default, no static RP is configured.
Note that:
PIM-SM or PIM-DM cannot be enabled on an interface that serves as a static RP.
■
When the ACL rule applied on a static RP changes, a new RP must be elected
■
for all the multicast groups.
You can configure multiple static RPs by using this command repeatedly.
■
However, if you carry out this command multiple times and specify the same
static RP address or reference the same ACL rule, the last configuration will
override the previous one. If multiple static RPs have been configured for the
same multicast group, the one with the highest IP address will be chosen to
serve the multicast group.
command to configure a static RP.
1427