State-Refresh-Rate-Limit (Ipv6 Pim View); Static-Rp (Ipv6 Pim View) - H3C MSR 20-20 Command Reference Manual

1500 C 93: IP 6 PIM C
HAPTER V
Parameter
Description
Related command:
Example

state-refresh-rate-limit (IPv6 PIM view)

Syntax
View
Parameter
Description
Related command:
Example

static-rp (IPv6 PIM view)

Syntax
C
ONFIGURATION OMMANDS
interval: State refresh interval in seconds, with an effective range of 1 to 255.
Use the state-refresh-interval
state refresh messages.
Use the
undo state-refresh-interval
By default, the state refresh interval is 60 seconds.
pim ipv6 state-refresh-capable, state-refresh-rate-limit (IPv6 PIM view), and
state-refresh-hoplimit.
# Set the state refresh interval to 70 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-interval 70
state-refresh-rate-limit interval
undo state-refresh-rate-limit
IPv6 PIM view
interval: Time to wait before receiving a new refresh message, in seconds and with
an effective range of 1 to 65535.
Use the
state-refresh-rate-limit
must wait before receiving a new state refresh message.
Use the undo state-refresh-rate-limit
By default, the device waits 30 seconds before receiving a new state refresh
message.
pim ipv6 state-refresh-capable, state-refresh-interval (IPv6 PIM view), and
state-refresh-hoplimit.
# Configure the device to wait 45 seconds before receiving a new state refresh
message.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-rate-limit 45
static-rp ipv6-rp-address [ acl6-number ] [ preferred ]
command to configure the interval between
command to restore the default setting.
command to configure the time the router
command to restore the default setting.