Dvpn Session Idle-Time; Ipsec Profile (Tunnel Interface View) - H3C MSR 20-20 Command Reference Manual

Related command:
Example

dvpn session idle-time

Syntax
View
Parameter
Description
Related command:
Example

ipsec profile (tunnel interface view)

Syntax
View
Parameter
interface tunnel on page 884 and tunnel-protocol on page 887.
# Set the quiet period to 100 seconds for VAM client abc when the attempts for
tunneling the Hub reach the maximum value.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] dvpn session dumb-time 100
dvpn session idle-time time-interval
undo dvpn session idle-time
Tunnel interface view
time-interval: Idle timeout for a Spoke-Spoke type DVPN tunnel in seconds, in the
range 60 to 1,800.
Use the
dvpn session idle-time
Spoke-Spoke type DVPN tunnel, that is, the tunnel will be removed automatically
if no data flows are transferred through a Spoke-Spoke type DVPN tunnel during
the idle timeout time.
Use the
undo dvpn session idle-time
By default, the idle timeout for a Spoke-Spoke type DVPN tunnel is 300 seconds.
Note that all VAM clients in a VPN domain must have the same configuration.
interface tunnel on page 884 and tunnel-protocol on page 887.
# Set the idle timeout for a Spoke-Spoke type DVPN tunnel to 600 seconds.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-tunnel0] dvpn session idle-time 600
ipsec profile ipsec-profile-name&<1-6>
undo ipsec profile [ ipsec-profile-name&<1-6> ]
Tunnel interface view
ipsec-profile-name&<1-6>: Name of the IPSec profile used for protecting data
packets and control packets passing through a DVPN tunnel, a case-insensitive
command to configure the idle timeout of a
command to restore the default.
1745