Remote-Ip - H3C MSR 20-20 Command Reference Manual

1556 C 95: MPLS B
HAPTER
Description
Example

remote-ip

Syntax
C C
ASICS ONFIGURATION OMMANDS
-h ttl-value: Specifies the TTL value for the echo request message. The ttl-value
argument ranges from 1 to 255.
-m wait-time: Specifies the interval for sending echo request messages. The
wait-time argument ranges from 1 to 10,000.
-r reply-mode: Specifies the reply mode in response to an echo request message.
The reply-mode argument can be 1 or 2. A value of 1 means "Do not response",
while a value of 2 means "Respond using a UDP packet".
-s packet-size: Specifies the payload length of the echo request message. The
packet-size argument ranges from 64 to 8,100.
-t time-out: Specifies the timeout interval for the response to an echo request
message. The time-out argument ranges from 0 to 65,535.
-v: Displays detailed response information.
ipv4 dest-addr mask-length: Specifies the LDP Ipv4 destination address and the
mask. The mask-length argument ranges from 0 to 32.
destination-ip-addr-header: Specifies the IP header destination address for the
MPLS echo request message, which can be any address on segment 127.0.0.0/8,
that is, any local loopback address.
te interface-type interface-number: Specifies a tunnel interface by its type and
number.
Use the
ping lsp
# Ping a specified address by send five packets.
<Sysname> ping lsp -c 5 ipv4 3.3.3.9 32
LSP PING FEC: LDP IPV4 PREFIX 3.3.3.9/32 : 100
RL_C to break
Reply from 100.1.2.1: bytes=100 Sequence=0 time = 31 ms
Reply from 100.1.2.1: bytes=100 Sequence=1 time = 62 ms
Reply from 100.1.2.1: bytes=100 Sequence=2 time = 62 ms
Reply from 100.2.3.1: bytes=100 Sequence=3 time = 62 ms
Reply from 100.1.2.1: bytes=100 Sequence=4 time = 62 ms
--- FEC: LDP IPV4 PREFIX 3.3.3.9/32 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 31/55/62 ms
remote-ip ip-address
undo remote-ip
command to check the validity and reachability of an LSP.
data bytes, press CT