Timer Query (Mld View) - H3C MSR 20-20 Command Reference Manual

Description
Related command:
Example

timer query (MLD view)

Syntax
View
Parameter
Description
Related command:
Example
Use the
timer other-querier-present
querier present interval globally.
Use the
undo timer other-querier-present
configuration.
By default, the MLD other querier present interval is determined by the following
formula:
MLD other querier present interval = [ MLD query interval ] times [ MLD querier
robustness variable ] plus [ maximum response delay for MLD general queries ]
divided by two.
n
By default, the values of the three parameters in the above-mentioned formula are
125, 2, and 10, respectively, so the default MLD other querier present interval is
125 x 2 + 10 / 2 = 255 (seconds).
mld timer other-querier-present, timer query (MLD view), robust-count
(MLD view), max-response-time (MLD view), and display mld interface.
# Set the MLD other querier present interval for non-queriers to 200 seconds
globally.
<Sysname> system-view
[Sysname] mld
[Sysname-mld] timer other-querier-present 200
timer query interval
undo timer query
MLD view
interval: Query interval, namely, amount of time in seconds between MLD general
query messages, in the range of 1 to 18,000.
Use the timer query
Use the
undo timer query
By default, the query interval is 125 seconds.
mld timer query, timer other-querier-present (MLD view), and display mld
interface.
# Set the query interval to 200 seconds globally.
<Sysname> system-view
[Sysname] mld
[Sysname-mld] timer query 200
command to configure the MLD other
command to configure the query interval globally.
command to restore the default configuration.
command to restore the default
1459