Qos Pq - H3C MSR 20-20 Command Reference Manual

1812 C 112: PQ C
HAPTER
Parameters
Description
Related commands:
Examples

qos pq

Syntax
View
Parameters
Description
Related commands:
C
ONFIGURATION OMMANDS
pql-number: Priority queue list number.
Use the display qos pql
all PQ lists.
Default items are not displayed.
qos pq, qos pq pql.
# Display PQLs.
<Sysname> display qos pql
Current PQL Configuration:
List Queue
------------------------------------------------------
1 Top
2 Normal
2 Bottom
3 Middle
qos pq pql pql-index
undo qos pq
Interface view
pql: Uses the parameters defined in specified PQ list.
pql-index: PQL index, in the range 1 to 16.
Use the
qos pq
Use the
undo qos pq
the interface to FIFO.
By default, the congestion management policy at the interfaces is FIFO.
Except for interfaces encapsulated with X.25, all physical interfaces can use PQ.
An interface can only use one group of priority lists.
This command can configure multiple classification rules for each group in the
priority list. During traffic classification, the system matches packets along the rule
list. If matching a certain rule, a packet will be classified into the priority queue
specified by this rule; or it will be put into the default priority queue.
qos pql inbound-interface, display qos pq interface, display qos pql,
display qos policy interface.
command to view contents of specified PQ list (PQL) or
Params
Protocol ip less-than 1000
Length 60
Length 40
Inbound-interface Ethernet1/0
command to apply a group of priority list to an interface.
command to restore the congestion management policy at