Reflect Between-Clients; Reflector Culster-Id - H3C MSR 20-20 Command Reference Manual

1708 C 98: MPLS L3VPN C
HAPTER

reflect between-clients

Syntax
View
Parameter
Description
Example

reflector culster-id

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
reflect between-clients
undo reflect between-clients
BGP-VPNv4 subaddress family view/BGP-L2VPN address family view
None
Use the
reflect between-clients
clients.
Use the
undo reflect between-clients
By default, route reflection between clients is enabled.
If fully meshed interconnections exist between the clients, route reflection is not
required. Otherwise, an RR is required for routes to be reflected from one client to
every other client.
# In BGP-VPNv4 subaddress family view, disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpnv4
[Sysname-bgp-af-vpnv4] undo reflect between-clients
# In BGP-L2VPN address family view, disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] l2vpn-family
[Sysname-bgp-af-l2vpn] undo reflect between-clients
reflector cluster-id { cluster-id | ip-address }
undo reflector cluster-id
BGP-VPNv4 subaddress family view/BGP-L2VPN address family view
cluster-id: Cluster ID of the route reflector (RR), in the range 1 to 4294967295.
ip-address: IP address of the peer, which is to be used as the cluster ID of the RR.
Use the reflector cluster-id
Use the
undo reflector cluster-id
command to enable route reflection between
command to disable the function.
command to specify a cluster ID for an RR.
command to remove the cluster ID.