Display Ripng - H3C MSR 20-20 Command Reference Manual

1310 C 85: IP 6 RIP
HAPTER V
Related commands:
Examples

display ripng

Syntax
View
Parameters
Description
Examples
C C
NG ONFIGURATION OMMANDS
By default, the default metric of redistributed routes is 0.
The specified default metric applies to routes redistributed by the import-route
command that has no metric specified.
import-route.
# Set the default metric of redistributed routes to 2.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100] default cost 2
display ripng [ process-id ]
Any view
process-id: RIPng process number, in the range of 1 to 65535.
Use the
display ripng
information of a RIPng process. If process-id is not specified, information of all
RIPng processes will be displayed.
# Display the running status and configuration information of all configured RIPng
processes.
<Sysname> display ripng
RIPng process : 1
Preference : 100
Checkzero : Enabled
Default Cost : 0
Maximum number of balanced paths : 3
Update time
Suppress time
Number of periodic updates sent : 0
Number of trigger updates sent : 0
Table 316 Description on the fields of the display ripng command
Field
RIPng Process
Preference
Checkzero
Default Cost
Maximum number of balanced paths
Update time
Timeout time
Suppress time
Garbage-Collect time
command to display the running status and configuration
: 30 sec(s) Timeout time
: 120 sec(s) Garbage-Collect time :
Description
RIPng process number
RIPng route priority
Whether zero field check for RIPng packet
headers is enabled
Default metric of redistributed routes
Maximum number of load balanced routes
RIPng updating interval, in seconds
RIPng timeout interval, in seconds
RIPng suppress interval, in seconds
RIPng garbage collection interval, in seconds
: 180 sec(s)
120 sec(s)