Display Ipv6 Interface Tunnel - H3C MSR 20-20 Command Reference Manual

display ipv6 interface tunnel

Syntax
View
Parameter
Description
Example
Table 468 Description on the fields of the display interface tunnel command
Field
Tunnel source
destination
Tunnel keepalive
Tunnel protocol/transport
GRE key
Checksumming of GRE packets
Last 300 seconds input
Last 300 seconds output
xxx packets input, xxx bytes
input error
xxx packets output, xxx bytes
output error
display ipv6 interface tunnel number
Any view
number: Tunnel interface number.
Use the
display ipv6 interface tunnel
about a tunnel interface.
# Display IPv6 information about interface Tunnel0.
<Sysname> display ipv6 interface tunnel 0
Tunnel0 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::101:101
Global unicast address(es):
2002:101:101::1, subnet is 2002::/16
Joined group address(es):
FF02::1:FF01:101
FF02::1:FF00:1
FF02::2
FF02::1
MTU is 1500 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
Description
Source address of the tunnel interface
Destination address of the tunnel interface
Whether the GRE keepalive function is enabled
Tunnel protocol/transport protocol
Secret key for tunnel interfaces use
Whether GRE packet checksum is enabled
Amount of inbound traffic per second in the last five
minutes, in bytes and in packets respectively
Amount of outbound traffic per second in the last five
minutes, in bytes and in packets respectively
Cumulative amount of inbound traffic, in packets and in
bytes respectively
Number of wrong packets in all inbound packets
Cumulative amount of outbound traffic, in packets and in
bytes respectively
Number of wrong packets in all outbound packets
command to display IPv6 information
1751