Qos Pql Queue - H3C MSR 20-20 Command Reference Manual

Description
Related commands:
Examples

qos pql queue

Syntax
View
Parameters
Table 483 Description on values of queue-key and key-value
queue-key key-value
greater-than Length, 0 to 65535
less-than Length, 0 to 65535
tcp Port number, 0 to
65535
udp Port number, 0 to
65535
-- --
When queue-key is tcp or udp, key-value can be port name or the associated port
number.
Use the
qos pql protocol
protocol type.
Use the undo qos pql protocol
classification rule.
By default, no rule is set.
The system matches a packet to a rule according to the set order. When the
packet matches a certain rule, the search process is completed.
For the same pql-index, this command can be repeatedly used, establishing
multiple classification rules for IP packets.
qos pql default-queue, qos pql inbound-interface, qos pql queue, qos pq.
# Specify PQ group number to 1 to make IP packets matching ACL 3100 be put
into the top queue.
<Sysname> system-view
[Sysname] qos pql 1 protocol ip acl 3100 queue top
qos pql pql-index queue { bottom | middle | normal | top } queue-length
queue-length
undo qos pql pql-index queue { bottom | middle | normal | top } queue-length
System view
pql-index: PQL index, in the range 1 to 16.
queue-length: Four length values of priority queues, in the range 1 to 1024.
Description
Any link layer frame greater than the specified
value is enqueued.
Link layer frames greater than the specified value
are enqueued.
Any IP packet whose source or destination TCP
port number is the specified port number will be
classified.
Any IP packet whose source or destination UDP
port number is the specified port number will be
classified.
All IP packets are enqueued.
command to establish classification rules based on the
command to delete the corresponding
1815