Mpls Te Commit - H3C MSR 20-20 Command Reference Manual

1620 C 96: MPLS TE C
HAPTER
Parameter
Description
Example

mpls te commit

Syntax
View
Parameter
Description
Example
C
ONFIGURATION OMMANDS
down: Sets the threshold in percentages for IGP to flood when the bandwidth is
decreasing. When the percentage of available bandwidth decrease exceeds the
threshold, the change is flooded and the traffic engineering database (TEDB) is
updated.
up: Sets the IGP flooding threshold in percentages that applies when the
bandwidth is increasing. When the percentage of available bandwidth increase
exceeds the threshold, the change is flooded and the TEDB is updated.
percent: IGP flooding threshold in percentages, in the range 0 to 100.
Use the
mpls te bandwidth change thresholds
flooding thresholds that apply when bandwidth resources are increasing and
decreasing.
Use the
undo mpls te bandwidth change thresholds
the default.
The default IGP flooding thresholds in both up and down directions are 10.
# On interface Ethernet 1/0 configure IGP to flood when the percentage of
available bandwidth decrease reaches 100%.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] mpls te bandwidth change thresholds down 100
mpls te commit
Tunnel interface view
None
Use the
mpls te commit
configuration.
The MPLS TE tunnel configuration you made can take effect only after you
perform this command.
# Configure an MPLS TE tunnel and submit the configuration.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] tunnel-protocol mpls te
[Sysname-Tunnel0] destination 2.2.2.9
[Sysname-Tunnel0] mpls te commit
command to submit current MPLS TE tunnel
command to set the IGP
command to restore