Debugging Bgp Detail - H3C MSR 20-20 Command Reference Manual

debugging bgp detail

Syntax
View
Default Level
Parameters
Description
Length: 19
*Aug 24 15:32:02:674 2006 Sysname RM/6/RMDEBUG:
BGP. : 10.1.1.2 Current event is RecvKeepAliveMessage.
*Aug 24 15:32:02:674 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 State is changed from OPENCONFIRM to ESTABLISHED.
// BGP has established the peer relationship successfully.
n
The display above is the debugging information shown by executing the
debugging bgp all command on Device A. If the peer relationship between two
devices cannot be established, you can compare the above debugging information
with the actual debugging information to locate the fault. For detailed
descriptions on the specific messages, refer to the commands below.
debugging bgp detail
undo debugging bgp detail
User view
1: Monitor level
None
Use the
debugging bgp detail
BGP.
Use the undo debugging bgp detail
for BGP.
Enabling debugging may affect system performance; therefore, use this command
only when necessary. Disable debugging once the debugging operation is
complete.
By default, detailed debugging for BGP is disabled.
Table 224 Description on the fields of the debugging bgp detail command
Field
BGP.xxx
BGP can't get physical interface index for
destination:X.X.X.X
Fail to search Token for destination X.X.X.X
Allocate token failed. destination=
X.X.X.X,LspmErr=X
There are XX routes allocate token failed at
this time before
Recv UPDATE with following RD XXX
command to enable detailed debugging for
command to disable detailed debugging
Description
BGP instance name
BGP cannot get the physical interface index
for destination X.X.X.X.
Token search for destination X.X.X.X failed.
Failed to allocate Token: destination X.X.X.X,
LSP error code X
Failed to allocate Tokens for XX routes
Received an Update message with RD XXX
1017