Description
Related commands:
Examples
rip input
Syntax
View
Parameters
Description
Related commands:
Examples
password: Plain text authentication string with 1 to 16 characters.
Use the
rip authentication-mode
mode and parameters.
Use the
undo rip authentication-mode
Note that the key string you configured can overwrite the old one if there is any.
rip version.
n
With RIPv1, you can configure the authentication mode in interface view.
However, the configuration will not take effect because RIPv1 does not support
authentication.
# Configure MD5 authentication on Ethernet1/0 with the key string being rose in
the format defined in RFC 2453.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] rip version 2
[Sysname-Ethernet1/0] rip authentication-mode md5 rfc2453 rose
rip input
undo rip input
Interface view
None
Use the
rip input
Use the
undo rip input
messages.
By default, an interface is enabled to receive RIP messages.
rip output.
# Enable Ethernet1/0 to receive RIP messages.
<Sysname> system-view
[Sysname] interface ethernet1/0
[Sysname-Ethernet1/0] rip input
command to configure RIP-2 authentication
command to enable the interface to receive RIP messages.
command to disable the interface from receiving RIP
command to cancel authentication.
1175