Debugging Bgp - H3C MSR 20-20 Command Reference Manual

debugging bgp

Syntax
View
Default Level
Parameters
Description
debugging bgp [ ipv4-address | ipv6-address ] { keepalive | open | packet |
raw-packet | route-refresh } [ receive | send ] [ verbose ] }
undo debugging bgp [ ipv4-address | ipv6-address ] { keepalive | open | packet |
raw-packet | route-refresh } [ receive | send ] [ verbose ] }
User view
1: Monitor level
ipv4-address: IPv4 address of a peer.
ipv6-address: IPv6 address of a peer.
keepalive: Enables BGP Keepalive message debugging.
open: Enables BGP OPEN message debugging.
packet: Specifies to enable BGP packet debugging
raw-packet: Enables BGP raw packet debugging.
route-refresh: Enables BGP Route-Refresh message debugging.
receive: Enables the debugging for received BGP packets.
send: Enables the debugging for sent BGP packets.
verbose: Displays detailed debugging information.
Use the
debugging bgp
message types.
Use the
undo debugging bgp
message types.
Enabling debugging may affect system performance; therefore, use the command
only when necessary and disable debugging once the debugging operation is
complete.
By default, this debugging is disabled.
Table 226 Description on the fields of the debugging bgp command
Field
Recv
Send
Length: LengthNumber
command to enable debugging for specific BGP
command to disable debugging for specific BGP
Description
Received packets
Sent packets
Packet length
1021