Radius Trap - H3C MSR 20-20 Command Reference Manual

1962 C 128: RADIUS C
HAPTER
Related command:
Example

radius trap

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
Use the undo radius scheme
By default, no RADIUS scheme is defined.
Note that:
The RADIUS protocol is configured scheme by scheme. Every RADIUS scheme
■
must at least specify the IP addresses and UDP ports of the RADIUS
authentication/authorization/accounting servers and the parameters necessary
for a RADIUS client to interact with the servers.
A RADIUS scheme can be referenced by more than one ISP domain at the same
■
time.
You cannot remove the RADIUS scheme being used by online users with the
■
undo radius scheme command.
key (RADIUS scheme view), retry realtime-accounting, timer
realtime-accounting (RADIUS scheme view), stop-accounting-buffer enable
(HWTACACS scheme view), retry stop-accounting (RADIUS scheme view),
server-type, state, user-name-format (RADIUS scheme view), retry, display
radius scheme, display radius statistics.
# Create a RADIUS scheme named radius1 and enter RADIUS scheme view.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1]
radius trap { accounting-server-down | authentication-server-down }
undo radius trap { accounting-server-down | authentication-server-down }
System view
accounting-server-down: RADIUS trap for accounting servers.
authentication-server-down: RADIUS trap for authentication servers.
Use the
radius trap
Use the
undo radius trap
By default, the RADIUS trap function is disabled.
Note that:
If a NAS sends an accounting or authentication request to the RADIUS server
■
but gets no response, the NAS retransmits the request. With the RADIUS trap
function enabled, when the NAS transmits the request for half of the specified
maximum number of transmission attempts, it sends a trap message; when the
command to delete a RADIUS scheme.
command to enable the RADIUS trap function.
command to disable the function.