If-Match Interface - H3C MSR 20-20 Command Reference Manual

1200 C 78: R
HAPTER OUTING
Description
Examples

if-match interface

Syntax
View
Parameters
Description
Related commands:
Examples
P C C
OLICY OMMON ONFIGURATION
&<1-16>: Indicates the argument before it can be entered up to 16 times.
Use the if-match extcommunity
list(s) for matching against the extended community attribute of routing
information.
Use the
undo if-match extcommunity
criterion.
The match criterion is not configured by default.
# Create a routing policy named policy1 with node 10, matching mode as permit.
Match the extended community attribute of routes against extended community
lists 100 and 150.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match extcommunity 100 150
if-match interface { interface-type interface-number }&<1-16>
undo if-match interface [ interface-type interface-number ]&<1-16>
Routing policy view
interface-type: Interface type
interface-number: Interface number
&<1-16>: Indicates the argument before it can be entered up to 16 times.
Use the
if-match interface
against the outbound interfaces of routing information.
Use the undo if-match interface
The match criterion is not configured by default.
if-match acl, if-match ip-prefix, if-match ip next-hop, if-match cost,
if-match tag, route-policy, apply ip-address next-hop, apply cost, apply
local-preference, apply origin, apply tag.
# Create a routing policy named policy1 with node 10, matching mode as permit.
Define an if-match clause to permit the routing information with the outbound
interface as Ethernet1/0.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match interface ethernet 1/0
C
OMMANDS
command to specify extended community
command to remove the match
command to specify interface(s) for matching
command to remove the match criterion.