Reflect Between-Clients (Ipv6 Address Family View) - H3C MSR 20-20 Command Reference Manual

View
Parameters
Description
Examples

reflect between-clients (IPv6 address family view)

Syntax
View
Parameters
Description
IPv6 address family view
external-preference: Preference of EBGP route learned from an EBGP peer, in the
range 1 to 255.
internal-preference: Preference of IBGP route learned from an IBGP peer, in the
range 1 to 255.
local-preference: Preference of IPv6 BGP local route, in the range 1 to 255.
route-policy-name: Routing policy name, a string of 1 to 19 characters. The
routing policy can set a preference for routes passing it. To the routes filtered out,
the default value applies.
Use the preference command to configure preferences for EBGP, IBGP, and local
routes.
Use the
undo preference
The bigger the preference value is, the lower the preference is. The default values
of external-preference, internal-preference and local-preference are 255, 255 and
130 respectively.
# Configure preferences for EBGP, IBGP, and local routes as 20, 20 and 200.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] preference 20 20 200
reflect between-clients
undo reflect between-clients
IPv6 address family view
None
Use the
reflect between-clients
clients.
Use the undo reflect between-clients
By default, route reflection between clients is enabled.
After a route reflector is configured, it reflects routes between clients. If the clients
are fully meshed, it is recommended to disable route reflection on the route
reflector to reduce costs.
command to restore the default.
command to enable route reflection between
command to disable this function.
1261