1726
C
99: VAM S
HAPTER
Description
Related command:
Example
keepalive interval
Syntax
View
Parameter
Description
Related command:
C
C
ERVER
ONFIGURATION
OMMANDS
public-ip-address: Public IP address of Hub.
Use the
hub private-ip
Use the
undo hub private-ip
specified Hub.
By default, no Hub IP address is configured.
Note that:
You can specify only the private IP address of Hub. When Hub is added to a
■
VPN domain, the VAM server can obtain the mapping information between the
registered public and private addresses of the Hub.
Currently, up to two Hub addresses can be configured on the VAM server.
■
vam server vpn.
# Specifies in VPN 1 the public and private IP addresses of Hub as 123.0.0.1 and
10.1.1.1 respectively.
<Sysname> system-view
[Sysname] vam server vpn 1
[Sysname-vam-server-vpn-1] hub private-ip 10.1.1.1 public-ip 123.0.0.1
keepalive interval time-interval
undo keepalive interval
VPN domain view
time-interval: Interval for sending keepalive message from VAM client. It is in the
range 5 to 60 seconds.
Use the
keepalive interval
keepalive messages from VAM client to VAM server.
Use the
undo keepalive interval
By default, the interval for sending keepalive message from VAM client is 10
seconds.
Note that the VAM server sends this setting in a registration response to its clients.
All clients in a VPN have the same keepalive settings, but if you change the
keepalive settings of the server, the new settings are sent to only clients that
register later; all clients registering before use the old settings.
vam server vpn, keepalive retry
command to specify the IP address of Hub.
command to remove the IP address of the
command to configure the interval for sending
command to restore to the default value.