Default; Bandwidth-Reference (Ospf View) - H3C MSR 20-20 Command Reference Manual

1110 C 76: OSPF C
HAPTER
Description
Related commands:
Examples

bandwidth-reference (OSPF view)

Syntax
View
Parameters
Description
Examples

default

Syntax
C
ONFIGURATION OMMANDS
Use the authentication-mode
the OSPF area.
Use the
undo authentication-mode
authentication mode.
By default, no authentication mode is configured for an OSPF area.
Routers that reside in the same area must have the same authentication mode:
non-authentication, simple, or MD5.
ospf authentication-mode.
# Specify the MD5 ciphertext authentication mode for OSPF area0.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 0
[Sysname-ospf-100-area-0.0.0.0] authentication-mode md5
bandwidth-reference value
undo bandwidth-reference
OSPF view
value: Specifies a bandwidth reference value for link cost calculation, in the range
1 to 2147483648 Mbps.
Use the
bandwidth-reference
for link cost calculation.
Use the
undo bandwidth-reference
The default value is 100 Mbps.
When links have no cost values configured, OSPF calculates their cost values:
Cost=Reference bandwidth value / Link bandwidth. If the calculated cost value is
greater than 65535, the maximum cost will be 65535.
# Specify the reference bandwidth value as 1000 Mbps.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] bandwidth-reference 1000
default { cost cost | limit limit | tag tag | type type } *
command to specify an authentication mode for
command to cancel a specified
command to specify a reference bandwidth value
command to restore the default value.