Reset Ospf Counters; Reset Ospf Process - H3C MSR 20-20 Command Reference Manual

Description
Examples

reset ospf counters

Syntax
View
Parameters
Description
Examples

reset ospf process

Syntax
route-policy-name: Rout policy name, a string of 1 to 19 characters.
value: Priority value, in the range 1 to 255. A smaller value has a higher priority.
Use the command to set the priority of OSPF routes.
preference
Use the
undo preference
The priority of OSPF internal routes defaults to 10, and the priority of OSPF
external routes defaults to 150.
If a routing policy is specified, priorities defined by the routing policy will apply to
matched routes, and the priorities set with the preference command apply to
OSPF routes not matching the routing policy.
A router may run multiple routing protocols. When several routing protocols find
routes to the same destination, the router uses the route found by the protocol
with the highest priority.
# Set a priority of 150 for OSPF internal routes.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] preference 150
reset ospf [ process-id ] counters [ neighbor [ interface-type interface-number ]
[ router-id ] ]
User view
process-id: OSPF process ID, in the range 1 to 65535.
neighbor: Clears neighbor statistics on an interface.
interface-type interface-number: Interface type and interface number.
router-id: Neighbor router ID.
Use the reset ospf counters
process is specified, counters of all OSPF processes are reset.
# Clear OSPF counters.
<Sysname> reset ospf counters
reset ospf [ process-id ] process
command to restore the default.
command to reset OSPF counters. If no OSPF
1153