Display Ospfv3 Vlink - H3C MSR 20-20 Command Reference Manual

1294 C 84: IP 6 OSPF
HAPTER V
Description
Examples

display ospfv3 vlink

Syntax
View
Parameters
Description
Examples
3 C C
V ONFIGURATION OMMANDS
area-id: The ID of an area, a decimal integer (in the range of 0 to 4294967295)
that is translated into IPv4 address format by the system or an IPv4 address.
Use the display ospfv3 topology
information. If no process is specified, topology information of all OSPFv3
processes is displayed.
# Display OSPFv3 area 1 topology information.
<Sysname> display ospfv3 topology area 1
OSPFv3 Area (0.0.0.1) topology
Type ID(If-Index)
Rtr 1.1.1.1
Rtr 2.2.2.2
Rtr 3.3.3.3
Rtr 4.4.4.4
Net 4.4.4.4(983049)
Table 314 Description on the fields of the display ospfv3 topology command
Field
Type
ID(If-Index)
Bits
Metric
Next-Hop
Interface
display ospfv3 [ process-id ] vlink
Any view
process-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535.
Use the
display ospfv3 vlink
information. If no process is specified, virtual link information of all OSPFv3
processes is displayed.
# Display OSPFv3 virtual link information.
<Sysname> display ospfv3 vlink
Virtual Link VLINK1 to router 1.1.1.1 is up
Transit area :0.0.0.1 via interface Serial2/0, instance ID: 0
Local address: 2000:1::1
Remote address: 2001:1:1::1
Transmit Delay is 1 sec, State: P-To-P,
Timer intervals configured, Hello: 10, Dead: 40, Wait: 40, Re
transmit: 5
command to display OSPFv3 topology
OSPFv3 Process (1)
Bits Metric
--
1
1
1
1
command to display OSPFv3 virtual link
Next-Hop Interface
2.2.2.2 Eth1/0
3.3.3.3 Eth1/0
4.4.4.4 Eth1/0
0.0.0.0 Eth1/0
Description
Type of node
Router ID
Flag bit
Cost value
Next hop
Outbound interface