Pim Ipv6; Pim Ipv6 Bsr-Boundary - H3C MSR 20-20 Command Reference Manual

1484 C 93: IP 6 PIM C
HAPTER V
Related commands:
Example

pim ipv6

Syntax
View
Parameter
Description
Related command:
Example

pim ipv6 bsr-boundary

Syntax
C
ONFIGURATION OMMANDS
MTU of the network. As a result, the products that do not support
fragmentation will drop the join/prune message.
The (S, G) join/prune state hold time on the upstream device. If you configure a
■
small queue size, the outgoing interface of the corresponding entry may have
been pruned due to timeout before the last join/prune message in a queue
reaches the upstream device.
jp-pkt-size (IPv6 PIM view), holdtime join-prune (IPv6 PIM view), pim ipv6
holdtime join-prune.
# Configure a join/prune messages to contain a maximum of 2,000 (S, G) entries.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] jp-queue-size 2000
pim ipv6
undo pim ipv6
System view
None
Use the command to enter IPv6 PIM view.
pim ipv6
Use the undo pim ipv6
PIM view.
IPv6 multicast must be enabled on the device before this command can take
effect.
multicast ipv6 routing-enable on page 1440.
# Enable IPv6 multicast routing and enter IPv6 PIM view.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] pim ipv6
[Sysname-pim6]
pim ipv6 bsr-boundary
undo pim ipv6 bsr-boundary
command to remove all configurations performed in IPv6