Rip Authentication-Mode - H3C MSR 20-20 Command Reference Manual

1174 C 77: RIP C
HAPTER
Parameters
Description
Examples

rip authentication-mode

Syntax
View
Parameters
C
ONFIGURATION OMMANDS
process-id: RIP process number, in the range of 1 to 65535. The default is 1.
vpn-instance vpn-instance-name: Specifies a VPN instance name, a string of 1 to
31 characters.
Use the command to create a RIP process and enter RIP view.
rip
Use the undo rip
By default, no RIP process is enabled.
Note that:
If no VPN instance is specified, the RIP process will run under public network
■
instance.
You must create a VPN instance before you apply a RIP process to it. For related
■
configuration, refer to "ip vpn-instance" on page 1696.
You must create the RIP process before configuring the global parameters. This
■
rule does not apply to interface parameters.
The configured interface parameters become invalid after you disable the RIP
■
process.
# Create a RIP process and enter rip process view.
<Sysname> system-view
[Sysname] rip
[Sysname-rip-1]
rip authentication-mode { md5 { rfc2082 key-string key-id | rfc2453 key-string } |
simple password }
undo rip authentication-mode
Interface view
md5: MD5 authentication mode.
rfc2453: Uses the message format defined in RFC 2453 (IETF standard).
rfc2082: Uses the message format defined in RFC 2082.
key-id: MD5 key number, in the range of 1 to 255.
key-string: MD5 key string with 1 to 16 characters in plain text format, or 1 to 24
characters in cipher text format. When the display current-configuration
command is used to display system information, a 24-character cipher string is
displayed as the MD5 key string.
simple: Plain text authentication mode.
command to disable a RIP process.