Trip Retransmit Timer - H3C MSR 20-20 Command Reference Manual

1184 C 77: RIP C
HAPTER
View
Parameters
Description
Examples

trip retransmit timer

Syntax
View
Parameters
Description
Examples
C
ONFIGURATION OMMANDS
RIP view
retransmit-count-value: Upper limit for retransmitting an Update Request or
Update Response, in the range 1 to 3600.
Use the
trip retransmit count
retransmitting an Update Request or Update Response.
Use the
undo validate-source-address
The default upper limit is 36.
# Configure an upper limit of 20 for retransmitting an Update Request or Update
Response.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] trip retransmit count 20
trip retransmit timer retransmit-time-value
undo trip retransmit timer
RIP view
retransmit-time-value: Interval in seconds for retransmitting an Update Request or
Update Response, in the range 1 to 3600.
Use the
trip retransmit timer
retransmitting an Update Request or Update Response.
Use the undo validate-source-address
The default interval is 5 seconds.
For two routers on an analog dial-up link, the difference between retransmission
intervals on the two ends must be bigger than 50 seconds; otherwise, they can
not become TRIP neighbors.
# Configure an interval of 80 seconds for retransmitting an Update Request or
Update Response.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] trip retransmit timer 80
command to configure the upper limit for
command to restore the default.
command to configure the interval for
command to restore the default.