Tunnel Select-Seq Load-Balance-Number - H3C MSR 20-20 Command Reference Manual

1718 C 98: MPLS L3VPN C
HAPTER
Description
Related command:
Example

tunnel select-seq load-balance-number

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
Use the tunnel-policy
tunneling policy view.
Use the
undo tunnel-policy
tunnel select-seq load-balance-number.
# Establish a tunneling policy named po1 and enter tunneling policy view.
<Sysname> system-view
[Sysname] tunnel-policy po1
[Sysname-tunnel-policy-po1]
tunnel select-seq { cr-lsp | gre | lsp }* load-balance-number number
undo tunnel select-seq
Tunneling policy view
cr-lsp: Specifies CR-LSP tunnels.
gre: Specifies GRE tunnels.
lsp: Specifies LSP tunnels.
number: Number of tunnels for load balancing, in the range 1 to 8.
Use the
tunnel select-seq load-balance-number
preference order for tunnel selection and the number of tunnels for load
balancing.
Use the
undo tunnel select-seq
By default, one LSP tunnel can be used. That is, only LSP tunnels can be used and
the number of tunnels for load balancing is 1.
Note that:
Only tunnels of the types specified in the tunnel select-seq
■
load-balance-number command can be used.
A tunnel type closer to the select-seq keyword has a higher priority.
■
The number of tunnels for load balancing refers to the number of tunnels that
■
an application can use.
CR-LSP tunnels are preferred by the following order: CR-LSPs configured with
ACLs, CR-LSPs bound with VPN, and ordinary CR-LSPs. These three types of
CR-LSPs are mutually exclusive, that is, only one type of the three is selected at a
time.
command to establish a tunneling policy and enter
command to delete a tunneling policy.
command to restore the default.
command to configure the